Post by barnydhppy on Aug 25, 2010 14:19:20 GMT -5
Link/description provided through this conversational thread: We Did It! Callicrate Dehorning!
**************************************************************************************
Dehorning cattle with the Callicrate Bander ...
*********************************************************************
Dehorning cattle with the Callicrate Bander ...
The Callicrate Smart Bander has been used successfully by producers to dehorn cattle of various sizes and ages. The technique employed by most producers is quite simple and very satisfactory.
Tetanus toxoid must be used. It is important to read and follow vaccine instructions. For more information, contact your veterinarian.
CAUTION: You must use adequate restraint on the heads of cattle. The head should be tied back to the side using a halter or nose tongs. A chute with adequate neck chain, neck extender or head sweep also works well. Electronic immobilizers are also a good choice when dehorning.
Click here for instructional de-horning slide show
* Put on safety glasses.
* Insert the end of the loop with the clip (SEAM SIDE UP) into the nose of the bander. (See figures 1 thru 6 on instructions.)
* Reach across the top of the animal’s head and place the loop over the horn furthest from you. Do not drag the loop along the bottom side of the horn. Dragging the loop along the bottom of the horn as you pull it toward the head will cause the loop to roll. If the loop rolls on the horn, it will tend to return to its original shape and roll back toward the tip of the horn.
* Pull the bander and loop toward you. This will keep the loop close to the head and in the hairline at the horn base.
* Tighten the loop until the tension peg on the bander touches the back of the slot.
* Press the crimping lever until it will go no further.
* Cut the loop as close to the spool as possible using the Callicrate Cutter.
* Some users recommend placing duct tape around the loop after it is applied to the horn.
* Repeat procedure on other horn.
Click here for instructional de-horning slide show
Expect the horns to fall off in 20 to 30 days for small to medium sized horns. Horns with large bases may take up to 50 days as experienced by some producers.
Ligation allows the horns to drop slowly, giving the holes at the base of the horn time to fill with tissue and thus no open hole into the sinus. Flies and maggots are not a problem, plus dirt and debris can not get into the sinus, reducing chances of infection.
**************************************************************************************
Dehorning cattle with the Callicrate Bander ...
*********************************************************************
Dehorning cattle with the Callicrate Bander ...
The Callicrate Smart Bander has been used successfully by producers to dehorn cattle of various sizes and ages. The technique employed by most producers is quite simple and very satisfactory.
Tetanus toxoid must be used. It is important to read and follow vaccine instructions. For more information, contact your veterinarian.
CAUTION: You must use adequate restraint on the heads of cattle. The head should be tied back to the side using a halter or nose tongs. A chute with adequate neck chain, neck extender or head sweep also works well. Electronic immobilizers are also a good choice when dehorning.
Click here for instructional de-horning slide show
* Put on safety glasses.
* Insert the end of the loop with the clip (SEAM SIDE UP) into the nose of the bander. (See figures 1 thru 6 on instructions.)
* Reach across the top of the animal’s head and place the loop over the horn furthest from you. Do not drag the loop along the bottom side of the horn. Dragging the loop along the bottom of the horn as you pull it toward the head will cause the loop to roll. If the loop rolls on the horn, it will tend to return to its original shape and roll back toward the tip of the horn.
* Pull the bander and loop toward you. This will keep the loop close to the head and in the hairline at the horn base.
* Tighten the loop until the tension peg on the bander touches the back of the slot.
* Press the crimping lever until it will go no further.
* Cut the loop as close to the spool as possible using the Callicrate Cutter.
* Some users recommend placing duct tape around the loop after it is applied to the horn.
* Repeat procedure on other horn.
Click here for instructional de-horning slide show
Expect the horns to fall off in 20 to 30 days for small to medium sized horns. Horns with large bases may take up to 50 days as experienced by some producers.
Ligation allows the horns to drop slowly, giving the holes at the base of the horn time to fill with tissue and thus no open hole into the sinus. Flies and maggots are not a problem, plus dirt and debris can not get into the sinus, reducing chances of infection.